Z1 Compact 5.0.2 Root Bootloader Kaldır Kaldırma 5.0.2 preroot

Home » Android » Z1 Compact 5.0.2 Root Bootloader Kaldır Kaldırma 5.0.2 preroot
Android Yorum Yapılmamış

Özlediniz beni biliyorum keretalar sizi.  z1 compact elime geçti sizin için root ve bootloader kaldırmadan telefon üzerinde ne tür fanteziler yapabileceğinizi göstericem .  Yok ben bootloader kaldırıcam diyorsanız bu işlemi sony üzerinden fastboot ile manuel yapabilir flashtool ile z1 seçip bootloader ı uçurabilirsiniz.

Yalnız kameranızda fantezilere sebep olabilir bootloader kaldırma haberiniz olsun :) Ben yaşadım 5 saatimi aldı.

Şimdiden uyarayım yok efenim telefonum uçtu açılmıyor bilmiyorsan korkuyorsan şimdiden uzaklaşabilirsin. Diğer konularda işine yarar bilgiler edinebilirsin.

Evet öncelikle sapkın gençler  şimdi telefonunuza flashtool ile 4.4.4 ftf yapıştırın linkleri veriyorum hazırmısınız .

Flashtool nedir bilmiyorsan bence şimdide konudan çıkabilirsin ama yinede yardım edeyim .

İnsafıma geldi bilgisayarınıza sony pc companion yüklü olması lazım bu bir  fastboot adb vs driver yüklü olması lazım bu 2

Burdan indiriyoruz flashtool u

http://www.flashtool.net/downloads.php

kurdunuz varsayıyorum sonrasında flashtool u açık flashmode diyip aşağıdan indirdiğiniz dosyayı (flashtool içinde firmware klasorune pompalıyoruz) seçip flash diyoruz. Tabi telefonu kapatıp ses kısmaya basılı tutarak usb yi telefona takıyoruz ne olmuş flash işlemi başlamış . İşlem bittikten sonra easy root dosyasıyla telefonu root luyorsunuz . Google dan bakabilirsiniz kolay işlem bunları anlatmıyorum. Sonra birde recovery kuruyorsunuz bunuda anlatmıyorum bunlar kolay işler her yerde resimli hali var.

download – http://firmwaremobile.com/index.php/…257-z1-compact

Google Drive – https://drive.google.com/file/d/0B_d…ew?usp=sharing

Mega – https://mega.co.nz/#!bBR2XQYI!TDouLm…eszzpzJtRzMNMs

source – http://xperiafirmware.com/8-firmware…-compact-d5503

 

Gelelim fasulyenin faydalarına

5.0.2 sizin için önceden hazırlanan pre root lu dosyamızı indirip sd card a yuvarlıyoruz. Recovery moda girip data ve cache dalvik wipe ediyoruz. Sonra bunu kuruyoruz. Bir açmışız 5.0.2 root lu halde orjinal rom u kullanıyoruz.  Aynı şekilde fantezi romları da deneyebilirsiniz vaktim kısıtlı olduğu için bu şekilde anlattım siz sordukça yardımcı olurum .

Download mirrorhttps://mega.co.nz/#!5NcTnIBY!7-gNci…WTvGHmXOOknabA

Biraz dua ederseniz sevinirim ihtiyacım var :)

Size bide ingilizce kaynak vereyim hadi iyisiniz.

The latest firmware build number for Xperia Z1 C6902 and C6903 is 14.5.A.0.242. It is based on Android 5.0.2 Lollipop. The firmware has been released a while ago. For power users, it is necessary to find the rooting method for the new firmware before updating their devices. This is important because most of power applications and modifications require root access. As soon as the firmware for Xperia Z1 is released, a new rooting method has also been designed for it.

This guide covers two topics; Rooting Xperia Z1 C6902 and C6903 on Android 5.0.2 Lollipoo 14.5.A.0.242 firmware, and the second topic is to install Dual Recovery (Philz Touch and TWRP) on Xperia Z1 Lollipop firmware. The Dual recovery is developed by NUT who is a recognized XDA developer and is currently supporting number of Xperia devices. To be able to follow this guide, you should keep in mind that there are three major steps. All the steps are explained in detail. All steps are explained will complete details so that any kind of error can be avoided. There are three main steps. Rooting KitKat firmware and downgrading if you have updated the device already. Creating the pre-rooted firmware and the third step is to root and install dual recovery in Xperia Z1. Make sure that you follow all the steps given below and complete all pre-required steps to avoid all kind of errors. The model number and build numbers are mentioned again and again throughout the post so that you do not mistakenly use this guide on any other smartphone or any other variant  of Xperia Z1.

1. This is only for Sony Xperia Z1 C6902 and Xperia Z1 C6903

This rooting method is only for the device mentioned above. Make sure that your model number matches the one listed above. To do so, go to Settings > About Device on your device and see your model number. Flashing this firmware on any other device will result in bricking it so make sure that you meet this requirement first of all.

2. Battery should be charged at least over 60%.

Make sure that your battery is charged enough to complete the flashing process. In case your battery is low and your device goes dead during the flashing process, you may end up soft bricking your device as it won’t complete the flashing process.

 

4. Enable USB Debugging Mode on your device.

Enable USB debugging mode on your device. To do so, tap settings>developer options>USB debugging. If you can’t find developer options in settings, then tap settings > about device and tap “Build Number” for 7 times and you’ll get em’ activated under settings.

5. Install and setup Sony Flashtool.

You must have installed Sony Flashtool.Download Flash Tool | Find the full guide here.

After installing Sony Flashtool, open the Flashtool folder from the drive where you installed it. Now open Flashtool>Drivers>Flashtool-drivers.exe and install the Flashtool, Fastboot & Xperia Z1 drivers from the list. If you do not find the Flashtool drivers in Flashmode, skip this step and install Sony PC Companion instead, for drivers support. [Important]

6. Use OEM data cable to establish connection.

Make sure that you use the phone’s original data cable to establish connection between your phone and the PC. Using a different data cable might result in interrupting the firmware installation.

7. Unlock Bootloader

Use the following guide to unlock the bootloader of your Xperia device before proceeding.

Steps For Rooting Xperia Z1 C6902/C6903 14.5.A.0.242 Firmware

1. Downgrade to .108 Firmware and Root It

  1. If you have already updated your smartphone to Android 5.0.2 Lollipop, then you have to downgrade your device to KitKat OS and Root it.
  2. Use this guide to Install .108 firmware.
  3. Root using this guide.
  4. Now Install XZ Dual Recovery.
  5. Now phone is rooted, USB Debugging must be enabled.
  6. Download latest installer for Xperia Z1 from here. (Z1-lockeddualrecovery2.8.10-RELEASE.installer.zip)
  7. Connect phone to PC using OEM date cable and run install.bat.
  8. It will install the custom recovery.
  9. Now work here is done. Lets move on to next step.

2. Make A Pre-Rooted Flashable Firmware For .242 FTF

  1. Download PRF Creator and install on your system.
  2. Download SuperSU zip and place anywhere on PC.
  3. Download .242 FTF and place it anywhere on PC.
  4. Download Z1-lockeddualrecovery2.8.10-RELEASE.flashable.zip
  5. Now run PRFC and add all three required files in it.
  6. Then click on Create.
  7. Once the Flashable ROM is created, it will show the successful message.
  8. Do not touch any other option while creating the pre-rooted firmware.
  9. Now copy the pre-rooted firmware to the phone’s internal storage.
  10. Our work in this step is now done. Move on to next step.

Note: If you do not want to create a pre-rooted flashable zip for your phone yourself, then you can download it for your phone’s specific model number and use it in the guide.

C6902 14.5.A.0.242 Pre-Rooted Flashable Zip | C6903 14.5.A.0.242 Pre-Rooted Flashable Zip

3. Root and Install Recovery on Z1 C6902/C6903 5.0.2 Lollipop Firmware

  1. Custom recovery was installed in the first step.
  2. The pre-rooted firmware was created and copied to phone in next step.
  3. Now you have to turn off phone.
  4. Turn it on again and press volume up or down repeatedly to enter custom recovery.
  5. Click on install and locate the folder where you placed the flashable zip earlier.
  6. Tap on it and install it.
  7. Now reboot the phone.
  8. If phone is still connected to PC via USB cable, disconnect it.
  9. Now go back to the .242 ftf you downloaded in second step and copy it to /flashtool/fimrwares
  10. Open flashtool and click on lightning icon in the top left.
  11. Click on it and click on flashmode.
  12. Select the .242 firmware.
  13. In the right bar, in the exclude options, exclude System only. It means that tick System only there. Leave every other options as it is.
  14. While flashtool prepares the software for flashing, turn off your phone.
  15. Keep the volume down button pressed and connect it to PC via USB cable.
  16. The button must be pressed during it.
  17. The phone will enter flashmode.
  18. Flashtool will automatically detect it and start flashing.
  19. After flashing phone will reboot and you will be done :)
  20. That’s all :) Enjoy
  21. Now your phone has a dual custom recovery, root access and of course latest Android 5.0.2 Lollipop Firmware.

LEAVE A COMMENT